Table Fan Rubber Buffer Big & Small Sizes

Manufacture of environment-friendly polymer plastics products masterbatch, filler masteratch, transparent masterbatch, etc.

Specifications: Density: 1.7 g/cm3; Appearance: White Pellets; Carrier: PE Application: PE985T can be widely used in the PE and PP recycling materials and the wetting plastic for blowing and injection. Features: 1. Reduction-prevention of moisture related problems including: porosity and lacing in products 2. Water absorption: it can absorb the water equivalent of 20% of its own weight 3. Without changing of the processing technology and equipments 4. Certified by SGS Usage: 1. Check the condition of inner packing and forbid using if damaged; 2. Use up within 16 hours after opening the inner packing; 3. Addition rate: 1%3%; 4. Simply mix with plastic raw materials; 5. Forbid drying with recycled plastic materials Simply mix with plastic raw materials.

Specifications: Density: 1.55 g/cm3; Appearance: Slight White Pellets; Application: A-218T can be used in ABS resin with high requirements for physical properties. Features: 1. Reduction-prevention of moisture related problems including: porosity and lacing in products 2. Water absorption: it can absorb the water equivalent of 20% of its own weight 3. Without changing of the processing technology and equipments 4. Certified by SGS Usage: 1. Check the condition of inner packing, forbid using if damaged; 2. Use up within 8 hours after opening the inner packing; 3. Addition rate: 1%5%; 4. Simply mix with plastic raw materials; 5. Forbid drying with wet plastic materials.

Specifications: density: 1.9g/cm3; appearance: slight white pellets; application: ny316 can be used in nylon resin and recycling nylon resin. Features: 1. Reduction-prevention of moisture related problems including: porosity and lacing in products 2. Water absorption: it can absorb the water equivalent of 20% of its own weight 3. Without changing of the processing technology and equipments 4. Certified by sgs usage: 1. Check the condition of inner packing, forbid using if damaged; 2. Use up within 8 hours after opening the inner packing; 3. Addition rate: 3%6%; 4. Simply mix with plastic raw materials; 5. Forbid drying with wet plastic materials.

Specifications: Density: 1.75 g/cm3; Appearance: White Pellets; Application: TM500 is applicable to PP and PE packing film, pipe and sheeting products. Features: 1. No change for the related processing technology and equipment 2. Featured with excellent transparency and increased opening performance 3. Saving cost and preventing non sizing of injection products 4. Certified by SGS Usage: 1. Addition rate: 10%30%; 2. Simply mix with plastic raw materials.